© Calibre UK Limited Issue 2.30 22
nd
April 2013
17
3.5.1. Display Type
Settings: LCD/Plasma, Projector
The Display Type setting defaults to Projector or to the last set before power down.
Select Projector if you drive a projector and need the warp function and edge blend capability.
Set to LCD/Plasma if you do not need warp (including Location). Multiple unit configurations with auto
zoom are available, but without edge blend. The real value of this mode is that the Flicker Filter
becomes available.
Note: For HQView-500S leave the setting to Projector mode, since there is no difference to LCD/Plasma
mode.
3.5.2. Output Mode
Settings: 640x480, 800x600, 1024x768, 1280x768, 1280x800, 1280x1024, 1360x768, 1366x768,
1400x1050, 1440x900, 1600x1200, 1680x1050, 1920x1200, 480i, 576i, 480p, 576p, 1080i, 720p, 1080p
Set up the desired output resolution with output mode. The output mode setting should match the native
resolution of the imaging device to avoid double scaling.
The 3GSDI output does not feature the PC mode resolutions, This is because PC modes are not part of
the international SDI standard. SDI supports only 480i/p, 576i/p, 720p and 1080i/p output modes.
Available SDI output modes are indicated by an SDI connector/BNC symbol in the output mode
selection list box of the OSD. SDI output modes not supported are indicated with this symbol crossed
out red.
The default output resolution as set by the factory or after a user issued factory reset is 640x480.
Note:- If only a SDI capable monitor is connected no image is displayed and consequently the output
resolution cannot by changes through the OSD.
Pressing the Menu/Contrast up/Contrast down key combination will switch the output resolution from
640x480 to 480i which SDI monitors should be capable to display.
If a DVI or VGA monitor has issues to display this 480i mode, by pressing the key combination again the
640x480 output mode is set-up which all DVI and VGA monitors should be capable to display.
3.5.3. Location
Settings: Front Tabletop, Front Ceiling, Rear Tabletop, Rear Ceiling
The image can be flipped to accommodate different projection scenarios as well as screens mounted
upside down.
3.5.4. Frame Rate
Settings: 60 Hz, 50 Hz, 48 Hz, 24 Hz, Auto
In auto mode the output frame rate follows the input frame rate as configured in the Output Config
menu.
Signals with 24Hz, 25Hz, 48Hz, 50Hz input modes get special treatment, Modes with other refresh rates
are displayed at 60Hz.
24Hz input modes will be output at 24Hz if the output resolution is set to either 720p or 1080p and the
Frame Rate setting in the Output Config menu includes 24Hz, otherwise it is displayed at twice the rate
if the Frame Rate setting in the Output Config menu includes 48Hz. Otherwise a 24Hz input mode is
displayed at 60Hz.
48Hz input modes will be output at 48Hz if the Frame Rate setting in the Output Config menu includes
48Hz. Otherwise it is displayed at 50Hz.
(30 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals